Short answer
Start by measuring the upright post, not the rail: standard Blacktail horse panels have 1-5/8 in posts and take the 1-5/8 in clamp, from $4.50. Use the adapter where a 1-5/8 in panel meets a 2-3/8 in post; kits already include their clamps, and cattle panels chain together instead.
| Post sizes | Where | Part | From |
|---|---|---|---|
| 1-5/8 in to 1-5/8 in | Horse panel to horse panel | 1-5/8 in panel clamp | $4.50 |
| 1-5/8 in to 2-3/8 in | Panel to a gate hang post or set ground post | Clamp adapter | $8.50 |
| 2-3/8 in to 2-3/8 in | Larger posts on both sides | 2-3/8 in panel clamp | $6.95 |
| 1-5/8 in post to wood | Timber held on a panel | Wood panel clamp | $7.95 |
Measure the outside diameter of the upright post before choosing a corral panel clamp. Standard Blacktail horse panels use 1-5/8-inch clamps, a 2-3/8-inch post takes the 2-3/8-inch clamp, and the adapter joins one size to the other.
Loose horse panels require panel connection clamps ordered separately. Round pen, stall, mare motel, shelter and arena kits include their clamps. Cattle panels do not use clamps at all; they connect with a pre-welded chain and chain keeper.
Connecting 1-5/8-inch horse panels
The galvanized and bare-metal 1-5/8-inch panel clamps connect matching horse-panel posts. Measure the upright, rather than the smaller horizontal rail.
Each clamp comes with its carriage bolt and nut. Put the smooth, rounded end of the bolt on the inside of the pen or stall so the animals cannot catch on the nut.
Connecting different post sizes
The galvanized adapter is for where a 1-5/8-inch panel meets a 2-3/8-inch post, such as a gate hang post or a set ground post. It is 3/16-inch steel, 5 inches long, with a 5/8-inch bolt hole, and the bolt and nut are included.
If both uprights are 2-3/8 inches, use the galvanized 2-3/8-inch panel clamp. The mixed-size adapter is not a substitute for a connection between two equally sized larger posts.
Kit hardware and loose panels
The complete 40 ft, 50 ft and 60 ft Blacktail round-pen kits include their listed panel clamps. Loose horse panels and individual additions to an enclosure require separate connection clamps.
Count the complete layout, gates and transitions when confirming hardware quantities. Mixing a different manufacturer’s panels may change the connection needed.
- Shop Horse Round Pen Kits
Compare available products, specifications and prices.
Wood clamps, posts and hinges
Wood-attach clamps hold timber to a panel and are different from panel-to-panel connection clamps. The round side fits a 1-5/8-inch panel post and the flat side takes a 2-inch-thick board. Wood-insert panels come either with wood insert clamps or with welded wood-insert mounts that fasten with lag bolts; timber and panel connection clamps are separate.
The hardware range also includes 8 ft posts and male or female post hinges. Compare the post diameter, hinge pin and mating part before ordering a replacement.
Continuous fence clips attach a permanent fence section to a set post. They do not serve the same purpose as a clamp joining freestanding panels.












