PBR Metal Roof Panels
26-gauge Galvalume PBR sheets in seven lengths from 6 to 24 ft. Each covers 3 ft of roof width once lapped, so count one sheet per 3 ft. Ridge caps are 12 x 40 in, bent for a 3:12 pitch. The same sheet we put on our own shelters.
Which roofing parts do I need?
A PBR roof is the sheets, the Z-purlins they screw to, and a ridge cap where two roof planes meet. Pick the part you're missing.
| Design | Best for | Where it goes | Shop |
|---|---|---|---|
| Galvalume PBR Roofing Panel | Roofing or siding a barn, shelter or shed row | On the purlins, or on a wall as siding | View |
| Galvalume Ridge Cap | Closing the peak of a two-sided roof | Along the peak, over the top sheets | View |
| Galvanized Z-Purlin | Carrying the sheets on a flat or sloped roof | Across the frame, under the sheets | View |
A complete shelter kit already includes its roof. Loose parts are for repairs, extensions and roofs built to your own design.
Read the roofing and purlin guideQuestions buyers ask
What does PBR mean?
Purlin bearing rib. The overlapping edge of the sheet sits flat on the purlin, so the lap screws down tight instead of bridging a gap. It's the standard exposed-fastener sheet for barns, shelters and shed rows.
How much does one sheet cover?
Each sheet is a few inches wider than 3 ft and covers 3 ft of width once it overlaps the next sheet. Count sheets by that 3 ft of coverage, not the full width.
How many sheets do I need?
One sheet for every 3 ft of roof width, rounded up: a roof 24 ft wide takes 8 sheets across. Then pick the length, 6, 8, 10, 12, 13, 20 or 24 ft, measured along the roof plane with any overhang. Laps, overhangs and the slope all change the final count, so check them against your roof design.
Do I need ridge caps?
Where two roof planes meet, such as an A-frame peak or a mare motel breezeway, a ridge cap covers the seam. Ours are 12 x 40 in Galvalume, bent for a 3:12 pitch, and fasten with self-drilling metal screws. Work out how many from the ridge length and the end laps.
What fastens the sheets to the roof?
Self-tapping screws with rubber washers, driven into the purlins. Check the profile of any sheets you're matching before you order.
Can I use PBR sheets as siding?
Yes. The same sheets are listed as roofing and siding panels. Measure the wall the same way you'd measure a roof plane.
Are these the same panels used on Blacktail shelters?
Yes. If you're repairing or extending a shelter we built, these are the same roof panels and ridge caps used on the original.
How much do PBR sheets cost?
Sheets run from $29.95 for 6 ft to $119.95 for 24 ft, and a ridge cap is $20. Those prices are for Galvalume. Pallet freight needs a forklift to unload. Freight to your address is shown at checkout, before you pay.





