Skip to content
Mare Motels — illustrative ranch setting

Mare Motel Kits in New Mexico

Mare motel kits delivered across New Mexico, from the Eastern Plains and the Pecos Valley to the Rio Grande Valley, Santa Fe and the Four Corners: 4 to 12 stalls under one roof, with standard or full cover. High-altitude sun, spring wind, caliche and snow at elevation decide which kit suits your place and how to set it up.

  • Made in the USA
  • 14-gauge welded steel
  • Freight quoted to your NM ZIP
  • Ask about installation

Mare motel kits for New Mexico

Caliche, sand and arroyos under a New Mexico mare motel

Across much of southern and eastern New Mexico, a layer of caliche, soil cemented hard with lime, lies anywhere from a few inches to a few feet under the surface. The Eastern Plains around Clovis, Portales and Hobbs have sandy and loamy soils above it. The Rio Grande Valley mixes river sand with heavier clay in the old farm fields along the bottomland, and the foothills around Santa Fe, Silver City and Ruidoso are rocky.

That matters because a mare motel stands on ground posts set in concrete: 12 holes for a standard 4-stall kit and 24 for a fully covered one. Caliche can stop a tractor auger cold, so a contractor with a rock bit or a breaker saves a lot of frustration. Loose sand caves into a hole as you dig, so a contractor may wet it down or use a form. On a hillside lot in the north, cut a level bench for the whole building, about 60 ft across, before you lay it out.

Then look for water, even on dry ground. Arroyos sit dry most of the year and run hard during summer storms, so never set the building in a wash, across one or at the foot of a slope that sheds water. In the Rio Grande and northern valleys, keep it off any acequia or irrigation ditch easement. A dirt contractor who works in your county can tell you what's under your site.

Altitude sun, spring wind and the monsoon around a mare motel

New Mexico runs from about 3,000 ft along the Pecos near the Texas line to more than 7,000 ft at Santa Fe, and the thin, dry air lets the sun through hard. Much of the Rio Grande Valley gets less than 10 inches of rain a year, and much of it falls in July, August and September. A standard-cover kit roofs the breezeway and the front 12 ft of each stall and leaves the back 12 ft open. In most of the state that open run dries quickly, and in winter a horse can stand in it to warm up. Around Las Cruces and Deming, where summer highs often pass 100, full coverage roofs the whole stall.

Spring brings the wind. From March into May, strong west and southwest winds cross much of the state and carry dust. The open ends of the breezeway funnel whatever blows along it, so on a site where that wind hits hard, a breezeway running north and south keeps the open ends out of it, and PBR siding closes the upper gap at the outer covered stall ends. In summer you'll want the air moving, so don't close off more than the wind requires.

Monsoon storms bring lightning, short heavy rain and sometimes hail, and the high valleys around Taos, Chama and Raton get real snow and hard freezes. The kit is not an engineered structure. Clear heavy snow from the roof before it builds up, and ask a local contractor how deep the posts need to go to get under the frost line where you are, since frost reaches deeper in the north than around Las Cruces.

Mare motels for New Mexico foaling farms, ranches and boarding barns

Breeding farms from the Sacramento Mountains to the Pecos Valley and the Mesilla Valley foal out mares each spring, and a foaling barn needs more room per horse than a boarding row. For foaling, the 24×24 kit gives a mare and foal twice the floor of a 12×24 stall, half roofed and half open. Choose five-rail or welded-wire panels so a foal can't slip a leg or head between the rails.

A boarding barn around Albuquerque, in Corrales, Los Lunas or the East Mountains, or near Santa Fe has to fit several stalls on a small lot. The 6- to 12-stall rows put every stall on one breezeway for feeding and cleaning. A ranch on the Eastern Plains keeping a few using horses, or a family with two or three horses, can start with the standard 4-stall kit. The catalog doesn't list an add-on for a mare motel, so growing later usually means a second building.

Rails, wire, wood and roof choices for a New Mexico mare motel

Kits run from 4 to 12 stalls, in pairs, with 12×24 or 24×24 stalls on a 12 ft breezeway. With 12×24 stalls, a 4-stall kit covers about 60 by 24 ft and each extra pair adds 12 ft of length. The kit page also offers a shed row, with all the stalls in one line, which can fit a narrow bench on a hillside lot better than two facing rows.

Four rails suit grown horses. Five rails, or welded wire in 5 ft or 6 ft panels, suit foals and young stock. Wood-insert panels and the Heritage Series, fully covered or with open runs, take boards you supply, and Heritage comes in a dapple grey powder coat. Lumber dries out fast in New Mexico air, so check the boards each spring and replace any that split. Wood is not included.

Bare metal is the standard finish and the least expensive. In dry air it takes longer to weather to its rust patina than it does in the humid South. Dapple grey, black or a custom powder coat costs more and keeps the color. Either way, the panels are 14-gauge steel.

Freight for a New Mexico mare motel, near the interstates or off them

A mare motel is a large load. A 4-stall kit has 20 panels and gate combinations, breezeway trusses, 25 ft Z-purlins, PBR roof sheets, ridge caps, clamps and ground posts. Large orders delivered near I-10 or I-40 ship free. Smaller orders near those highways ship at a flat rate. The delivery page gives the order size and how close to the highway counts. Places well away from the interstates, like Farmington, Taos, Roswell or Carlsbad, are priced on distance. Freight is priced from the road miles to your address, as one load, with a $200 minimum. You see the amount before you pay.

The driver brings the load to your place but doesn't unload it. Have a tractor or skid steer with forks, and a few people for the long purlins and roof sheets. The last miles are often the hard part: soft sand, a wash crossing, a two-track or a dirt road that turns to mud after a monsoon storm can stop a loaded truck. Meet it on firm ground or at the paved road if you need to, and tell us about cattle guards, low lines or tight gates when you order.

Posts, concrete and permits for a New Mexico mare motel

Every kit includes its ground posts and hardware. You set the posts in concrete, which isn't included, then clamp the panels to them; don't concrete the panel legs. A standard 4-stall kit uses 64 clamps and needs no welding. The breezeway roof is 9 to 10 ft high, so plan on ladders or a lift and a crew of two or three to set the trusses, run the purlins and screw down the roof sheets. Installation is available and quoted separately.

Mare motel kits are not engineered and are not built to a specific building code, so ask before you order. Start with your county or city building office and ask whether the building needs a permit. Subdivisions around Rio Rancho, Edgewood and Santa Fe may have HOA or covenant rules about outbuildings, so read those too.

New Mexico mare motel questions

Still deciding? Call (619) 914-6657

How much does a mare motel cost in New Mexico?

It depends on the layout. Stall count, individual stall dimensions, roof coverage, rail count, and selected finish determine the kit price. Wood-insert models exclude the wood. Send the layout you have in mind and your ZIP code, and we’ll quote the equipment and the freight to your property.

Do you deliver to my part of New Mexico?

Yes. We ship anywhere in New Mexico, and freight to your property is quoted with the equipment. Tell us about access, such as gate widths or a steep drive. You unload, so plan for a tractor with forks, a skid steer or enough people.

Do you install mare motels in New Mexico?

We offer installation for mare motels, quoted separately from the equipment and freight. Send your address and site photos, and we’ll confirm availability, scope and scheduling for your property with the quote. Site preparation and permits remain your responsibility.

How do I get a New Mexico mare motel quote?

Fill in the quote form on this page, call (619) 914-6657 or email info@blacktailcorrals.com. Send your project location, a sketch or photos, the stall count and the roof coverage you are considering. We can discuss the configuration before you choose a kit.

Does caliche make it hard to set mare motel posts in New Mexico?

It can. Caliche is soil cemented hard with lime, and it can stop a tractor auger. A contractor with a rock bit or a breaker gets through it. Dig each post hole to the depth your contractor or county recommends, set the posts in concrete and clamp the panels to them. Concrete is not included in the kit.

Which way should a mare motel face in New Mexico's spring wind?

Where strong spring wind comes from the west or southwest, a breezeway running north and south keeps the open ends out of it, and PBR siding closes the upper gap at the outer covered stall ends. Leave enough open that summer air still moves through, and watch how the wind actually crosses your site before you set posts.

Is standard cover enough for a mare motel in southern New Mexico?

Often, yes. The open rear runs dry fast in the desert and give horses winter sun. Around Las Cruces and Deming, where summer highs often pass 100, full cover roofs the whole 24 ft depth of each stall instead of the front 12 ft. Think about how many hours horses stand in the stalls in July before you choose.

Can a mare motel take the snow in northern New Mexico?

The kits are not engineered structures or rated for a snow load, so don't let snow build up on the roof. Around Taos, Chama, Raton or Angel Fire, clear heavy snow from the roof before it builds up when you can do it safely, check the clamps and bolts after a big storm, and ask a local contractor how deep the posts should go to get under the frost line. A fully covered kit has more roof to clear than a standard-cover kit.

Planning a project in New Mexico?

We deliver across New Mexico, from Albuquerque, Santa Fe, Las Cruces and beyond. Send your city or ZIP and we’ll quote freight to your property.

How can we help?

Call us at (619) 914-6657

Tell us what you’re building in New Mexico. We’ll help with the layout and quote the equipment and freight, plus installation if you want it.